Stream
Last updated
Last updated
Global configuration Here you can uniformly set common protocol switches for all channels, including: HTTP(TS), HLS, RTMP（Server/Pull）, RTSP, UDP(multicast/unicast), Push(rtmp,rtsp,srt .etc)
Which muticast addrsupports auto-increment settings for IP or Port:
For example, if "233.233.2.1:3000+" is set, the channel multicast addresses are: "233.233.2.1:3000", "233.233.2.1:3001", "233.233.2.1:3002"......
For example, if "233.233.2.1+:3000" is set, the channel multicast addresses are: "233.233.2.1:3000", "233.233.2.2:3000", "233.233.2.3:3000"......
Note that multicast requires the network environment to allow it, usually a switch with IGMP management function and proper configuration. If UDP unicast is required, just change the multicast address to the IP address of the target device.
It is used to set the common output protocol switch and address of each pass, among which the push stream address supports push stream protocols such as rtmp/rtsp
It is used to set the parameters of mpegts encapsulation in HTTP and multicast (UDP) protocols. For details, refer to the definition of mpegts format.
Flow control, Bandwidth: Two parameters are used to limit the maximum rate of UDP sending to prevent packet loss caused by sending too fast.
RTP Head: When this switch is turned on, the TS stream sent by UDP will carry an additional RTP header.
Note that in order to protect the life of Flash, HLS fragment data is stored in memory. Setting too large a fragment length or list number will result in insufficient memory.
For the configuration of the relevant parameters of the SRT protocol, please refer to the relevant description of the srt protocol for specific parameter meanings, or refer to the example description in [Third-party software access -> vMix]. You can also refer to the blog post "Introduction to the Three Modes of the Encoder SRT Protocol (listener, caller, rendezvous)": https://linkpi.cn/archives/1027
Note that the parameter modification of SRT needs to be restarted to take effect, and the password must not be less than 10 characters.
NDI name: used for the channel name displayed during NDI auto-discovery
NDI group: It is recommended to leave blank
encode: NDI output switch of the channel
Note that if you purchase an encoder without NDI authorization, it can only be used for 30 minutes each time NDI is turned on.
Push config
HEVC ID: Since the flv package used by standard rtmp does not support HEVC (H.265) temporarily, it is necessary to expand the package with a custom extension ID. The general ID for domestic platforms is 12
Format: It is recommended to choose auto
Push speed: When the channel push stream is enabled, the real-time push stream upstream rate can be displayed here.
As shown in the figure above, according to the output protocol you currently open, all playable protocol addresses will be organized in this interface, which is convenient for copying to other playback systems.
